Possible malfunctions карданной transfers and ways of their elimination
Cause of defect	Way of elimination
Knock in карданной to transfer at sharp change of movement of the car or at a gear change
Deterioration of bearings and thorns крестовин in hinges	To check up a radial backlash in bearings of hinges and if it exceeds 0,10 mm, to replace крестовину and bearings
Ослабло shaft fastening to a flange of a leading gear wheel of the back bridge	To tighten fastening by the set moment
Vibration карданной transfers
The balancing plate is lost	To make dynamic balancing of a shaft
The plug of an intermediate shaft is incorrectly established шлицевая	To establish шлицевую a plug in one plane with a sliding plug
Ослабло fastening of an intermediate support to a cross-beam the Raised palpation of a sliding plug in the transmission extension piece	To tighten fastening
Deterioration or breakage of one of hinges	Originally to turn a plug on шлицах on a corner 180 ° and to check up, whether palpation will decrease. If it does not decrease to replace the worn out details. At replacement шлицевой plugs a shaft dynamically отбалансировать
Breakage or damage of a flange of a leading gear wheel of the back bridge	To replace the hinge
Погнута or the pipe карданного a shaft is removed	To replace a flange
Ослабло shaft fastening to the back bridge	To examine a shaft, to check up its palpation and if it exceeds 0,8 mm, отрихтовать it, thus its palpation should be no more than 0,6 mm in any point on length. Отбалансировать a shaft dynamically. To tighten fastening
Malfunctions which come to light at survey
Проворачивание a cap with a cuff concerning a bearing glass (infringement of tightness of the hinge)	To replace крестовину in gathering with the bearing. Отбалансировать transfer
Проворачивание a bearing glass in plug apertures	To replace the worn out details, отбалансировать transfer